Set Pump Run Time in Probeless Mode – Brightwell Q200
In probeless mode, the Brightwell Q200 relies on pump run time instead of conductivity sensors to deliver the correct amount of chemical. This setup is ideal where sensor-based dosing is not feasible or where simplicity is preferred.
In this short guide, we’ll show you how to set the pump run time on a Q200 operating in probeless mode, ensuring consistent and safe dosing.
⚙️ What Is Probeless Mode?
In probeless mode, the Q200 doesn’t detect conductivity but instead uses fixed time-based control for the chemical pump. The system activates the pump for a pre-set number of seconds per dosing cycle.
This setup requires accurate configuration to avoid over- or under-dosing.
⏱️ How to Set the Pump Run Time
- Access the Q200’s Settings Menu
- Navigate to the Probeless Mode section
- Select Pump Run Time
- Input the desired run time (in seconds)
- Confirm the setting with the tick/check button
- Test the system to ensure chemical flow matches operational needs. Regular monitoring is recommended to maintain accuracy.
🛠️ Need Help with Dosing Settings?
24 NRG Group provides installation, configuration, and ongoing support for Brightwell Q200 systems. If you’re unsure how to set pump run time or switch dosing modes, our team can help.
